I need to combine a control bypass with series/parallel, out of phase, bridge paralleled and have had no problems with bypass in the past because I used a 4p2t push pull- However, as discussed in a separate thread (https://forum.seymourduncan.com/showthread.php?323683-Source-for-4pdt-push-pull-pot&highlight=4p2t ), 4p2ts seem to be out of production and we will have to use 4 * dpdt pushpulls.
As a result, I changed the design to bypass controls for the neck only, however, that diagram doesn't appear to work- If you look at the following, it appears that the negative side of the pickup may still be passing thru vol and/or tone.
I really need guru input, because this mod is apparently possible (there is an incomplete diagram on SD site.)
I've also spent so much time on the bypass that I threw this together much faster than normal and would appreciate a sanity check on the rest of the circuit as well.
Thanks so much in advance!
As a result, I changed the design to bypass controls for the neck only, however, that diagram doesn't appear to work- If you look at the following, it appears that the negative side of the pickup may still be passing thru vol and/or tone.
I really need guru input, because this mod is apparently possible (there is an incomplete diagram on SD site.)
I've also spent so much time on the bypass that I threw this together much faster than normal and would appreciate a sanity check on the rest of the circuit as well.
Thanks so much in advance!
Last edited:
