Combo speaker?

A

Ahpook

New member
Hello everyone. I have a DSL 40CR that I use with an extension 2x12 cabinet. The combo internal speaker is just unplugged, but the wires going to the actual speaker are still intact. I was thinking about removing the speaker completely from the amp if that is possible without blowing anything up :) It would certainly be lighter to carry, but unsure if that would cause any electrical issues.

Since I don't plan to use the internal it would be great to get rid of it. I could even go one step further and make the DSL a head. But, that will come later if at all.

Thanks
 
You can certainly pull the speaker without affecting the amp, as long as you always have another speaker combination of the correct ohmage connected to the amp output.

Sent from my SM-A115A using Tapatalk
 
Demanic said:
You can certainly pull the speaker without affecting the amp, as long as you always have another speaker combination of the correct ohmage connected to the amp output.

Sent from my SM-A115A using Tapatalk
Click to expand...

Great to hear! I use a 2x12 Orange cab plugged in the 16ohm jack.

Thank you
 
Cut it down to just a head

It will be much lighter

The trouble with doing this is that heads amd combos sound different

In a combo
the tubes hang under the circuit board and heat rises

In a head
The tubes are on top of the circuit board and heat still rises
 
If possible, just find a DSL head on the used market and then sell the combo.

Cutting a combo down to a head places it in a weird mutant format when somebody else could have used it just the way it was.
 
Last edited:
yeah, i wouldnt cut it down. if you wanna pull the speaker to save a few pounds, go ahead, but if you really want a head then sell the combo and buy one
 
You must log in or register to reply here.
Back
Top