Copper tape glued to aluminum

[CarlosG]

Hi!
Can i put copper tape on aluminum? This usually applies to pickguards in Strat where there is a partial aluminum shield.
In electrical engineering such connections are not allowed due to corrosion. But it is a shielding through which no current flows, so?
Best regards

 

[ICTGoober]

You are forgetting the adhesive...

 

[ehdwuld]

Answer is yes
skip the glue

 

[Chistopher]

In electrical engineering such connections are not allowed due to corrosion.

What do you mean by this?

 

[CarlosG]

What do you mean by this?

I am an electrician.If you connect copper to aluminum directly, corrosion will occur, the joint will heat up, and eventually fail.
In such connections, special al/cu or stainless steel washers are used.
I was curious if such a phenomenon also occurs in the guitar, where the current flowing through the shield is almost equal to 0.

 

[ehdwuld]

The voltage of the shielding of a guitar is too low to heat up

Your main concern is contact

Which shouldn't be a problem

 

[uOpt]

Current is flowing through the shielding but way too little to lead to corrosion.