Difference in tone when split?

Danjel

New member
I was wondering if there will be any difference in tone (humbucking mode) if I were to wire a "Pearly Gates" for split vs not wired for split? If so, what would the difference be?
Thanx!
Danjel
 
Re: Difference in tone when split?

Could you elaborate a bit more on what you mean and what your goal is?

From the pedestrian approach, "split" is pretty much splitting a humbucker. You get one of the coils instead of two. Based on the wiring schematics available, you can chose which coil you wire up for the split. This will lose the hum bucking feature. It is. It exactly like a single coil, but very close...as in, you are only using one coil, but you will not have the physical design of a single coil.

The way you are asking your question, it does look as if you might be asking a different question.


Sent from my armored space station via iPad using Tapatalk
 
Re: Difference in tone when split?

Yes, I thought the question might be misunderstood...
I know the difference between a coil split and not.
I mean, if there is any tonal difference between a guitar wired for coilsplit (humbucker mode) and a guitar not wired for coilsplit at all. Same guitar, same pickup (Pearly Gates).
 
Re: Difference in tone when split?

If the pickup stays in series humbucking mode from the switch,then no difference from not having the switch at all.
 
Last edited:
Re: Difference in tone when split?

"split" is pretty much splitting a humbucker. You get one of the coils instead of two... It isn't exactly like a single coil, but very close...as in, you are only using one coil, but you will not have the physical design of a single coil

Ah, but actually you do. 'Single coil' includes P-90's, 'Alnico' staple PU's, 'Charlie Christian' PU's, and others. There is much more to the world of single coils than Fender's versions. There were single coils in production guitars years before Leo introduced his. An HB with one coil active is also true single coil. It won't sound like a Fender single coil because it has a bar magnet under the pole pieces and the wire is wrapped around a bobbin, whereas as Fender's have magnetic pole pieces and no bobbin.

In answer to the OP's questions, being wired for coil cut doesn't alter the sound at all, until you actually shut off one of the coils (usually via push-pull).
 
Re: Difference in tone when split?

There should be no difference. Just like there should be no difference in sound between a 2-conductor PG and a 4-conductor PG.
-
Austin
 
Back
Top