FINALLY ordered pups! Wiring Gurus please...

[VTM Mike]

After much deliberation I decided on a PG bridge and an APll neck in my mahogany Iceman warmoth project. So now that my neck, hardware AND pickups are shipped and on the way, I want to get my wiring plan figured out. 3 way, 3 controls. Tone knob isn't necessary. Series, split parallel for both pups. I believe the diagram SD shows for this is just series/parallel. I would like to split both of these, and maybe use different combinations of splits. Thanks in advance.

 

[Robert S.]

Re: FINALLY ordered pups! Wiring Gurus please...

http://www.seymourduncan.com/suppor...ics.php?schematic=series_spl_parallel-w-phase

That diagram shows how to get series-split=parallel with an on-on-on dpdt switch. You can ignore the phase portion. The black that leaves the s-s-p switch is hot and the grey is ground.

 

[VTM Mike]

Re: FINALLY ordered pups! Wiring Gurus please...

So lets say I have 3 push pulls and a 3 way. (I do, by the way) What can I do and how do I do it. (schematic) Thanks

 

[VTM Mike]

Re: FINALLY ordered pups! Wiring Gurus please...

I would like to enable each pup to operate in series, parallel, and split coils. If I can combine neck and bridge splits, that would be a bonus (like both screw coils, or 1 screw from the neck, slug from bridge simulataneously,etc. Or a phase reversal option would be a consideration as well. I just need to see where the wires go, and I will try different things. To summarize:
1. Series/parallel with coil split
2. Series/parallel with phase
3. Series/parallel with split and phase

 

[VTM Mike]

Re: FINALLY ordered pups! Wiring Gurus please...

Wow. That's awesome!! I will get rolling on my '79 Iceman, which is wired series/parallel. I'll swap in a push pull tone knob and give it a try. Then when I do the new guitar I'll know what to do. Thanks alot. Nice work!