Frets look flakey

Techy Beccy

Techy Beccy

New member
I've noticed some of my frets on my maple neck telecaster appear to be flaking. It feels rough when I run my fingers over the side of them. Anyine have any experience with this?
5CD298B9-BBD8-4F30-A50E-E8C6941F12CA.jpg
2117B41B-FBC7-4AD5-90F5-B07DB87AF23F.jpg
A48F764D-0D16-4B1A-8A9D-BC5824000F08.jpg
83748831-6A1D-4F55-AF57-4234751E71E5.jpg
 
Re: Frets look flakey

full maple necks are often finished in a hard finish and the finish goes over the frets. Then, the frets are beveled, leveled, crowned and buffed. Sometimes the finish isn't cut off perfectly and voila, you get what you're seeing. Any luthier worth his/her salt should be able to clean this up and buff this out. Or, just deal with it and ignore it. As long as the string doesn't feel raspy over the frets, you're fine.
 
Re: Frets look flakey

Tape them off and hit them with OOOO steel wool.

Sent from my REVVLPLUS C3701A using Tapatalk
 
Re: Frets look flakey

Tape them off and hit them with OOOO steel wool.
Click to expand...

NEVER use steel wool on an electric guitar. NEVER.
Use Scotchbrite - it's non-magnetic, doesn't rust, doesn't crumble into tiny shreds that hurt your fingers.
 
Re: Frets look flakey

Start with light gray, it cuts slower. The maroon cuts faster. NOW - since the finish is maple, you can expect the Scotchbrite to mark up the lacquer, so tape it off between the frets and be careful. Unless you are shooting for a dull finish and feel - then just apply some elbow grease until you are happy.
 
Re: Frets look flakey

orpheo said:
full maple necks are often finished in a hard finish and the finish goes over the frets. Then, the frets are beveled, leveled, crowned and buffed. Sometimes the finish isn't cut off perfectly and voila, you get what you're seeing. Any luthier worth his/her salt should be able to clean this up and buff this out. Or, just deal with it and ignore it. As long as the string doesn't feel raspy over the frets, you're fine.
Click to expand...
Thanks!
I thought that may be the case, but wanted to ask!

I think I'll just polish the top of the frets and wipe down the board. I dont want to peel back the finish seeing as its seeling the board.

I use fine steel wool occasionally on rosewood fretboards only. Usually they stay pretty clean. I might look into the 3m sounds good!
 
Re: Frets look flakey

ICTGoober said:
NEVER use steel wool on an electric guitar. NEVER.
Use Scotchbrite - it's non-magnetic, doesn't rust, doesn't crumble into tiny shreds that hurt your fingers.
Click to expand...
I used this technique for 35+ years. I guess I'm just lucky.

Sent from my REVVLPLUS C3701A using Tapatalk
 
You must log in or register to reply here.
Back
Top