RockStarNick
New member
FS: MojoAxe "CWT" compensated wraparound tailpiece. Aged nickel.
If you're reading this, you know the MojoAxe TP is the most vintage-correct looking intonated wraparound on the market today. Read all about it here:
http://www.mojoaxe.com/
Note: This tailpiece has been slightly modified by me. I carefully enlarged the treble-side post notch, to allow approximately 1/8" extra travel in the intonation range. This allows the tailpiece to get to the proper steep vintage angle, in order to intonate properly on modern guitars with a shallower stud angle.
Stability was not compromised at all (Especially with the use of Tonepros locking studs).
New, this cost me $139 + Shipping.
Because of the mod, I'm discounting it accordingly.
I'd like to get $95 Shipped.
Top plating and notch extension are clean as a whistle. Bottom has a SMALL area where a tiny chip of nickel flaked off, but otherwise, nickel plating is completely intact and solid.
If you're reading this, you know the MojoAxe TP is the most vintage-correct looking intonated wraparound on the market today. Read all about it here:
http://www.mojoaxe.com/
Note: This tailpiece has been slightly modified by me. I carefully enlarged the treble-side post notch, to allow approximately 1/8" extra travel in the intonation range. This allows the tailpiece to get to the proper steep vintage angle, in order to intonate properly on modern guitars with a shallower stud angle.
Stability was not compromised at all (Especially with the use of Tonepros locking studs).
New, this cost me $139 + Shipping.
Because of the mod, I'm discounting it accordingly.
I'd like to get $95 Shipped.
Top plating and notch extension are clean as a whistle. Bottom has a SMALL area where a tiny chip of nickel flaked off, but otherwise, nickel plating is completely intact and solid.
