H H H (middle=singlecoil sized) wiring!

[kap_x]

I just got a new 5 way switchport, new 500k CTS pots for my ibanez S series electric.

I have it H H H with the middle singlecoil sized hum, and im wondering the the best way to wire it....not ibanez style wiring since its a humbucker in the middle


also, i need it to compensate for the 59' neck single cable with wire shielding..

anyhelp?
just like...


x
-x
x
-x
x
-x
x
-x

(the hyphens (-) signify the other side of the switch, because it wouldnt format correctly with just a space...so i used a hyphen)
if that was the switch (top facing neck) solderpoints, what should i put where.
if it helps, im using a 59n, duckbucker middle, and i have stock bridge (soon to be screamin demon or jp, and duckbucker to coolrails, 4 conductor)

any help is much appreciated!

(this is my first post in the new forum! yay, so i get to start my membership all over..hehe)

thanks guys!

 

[Robert S.]

Re: H H H (middle=singlecoil sized) wiring!

http://www.seymourduncan.com/website/support/schematics/3lil_hb_vol_2tones_5way.html

This schematic shows the basics of the wiring. Depending on your volume and tone control layout a section of the schematic may be different. Ibanez isn't known for using 2 tone controls like Fender does on the Strat.

But the 5-way layout is correct.

 

[kap_x]

Re: H H H (middle=singlecoil sized) wiring!

so what would i do with the 59 since its not 4 conductor, and what changes should make to compensate for only 1 tone pot? :smack: