Help me mod my Fuzz Face? Please.

O

Onslow

New member
I bought a thing of 1k-ohm resistors for the output and a thing of 10k-ohm resistors for the trim pot bias. Trouble is, I can't find the website I was going by and I have no idea exactly which ones I'm supposed to remove and replace on the circuit board for the ouput and trim. I tried to follow the paths on the circuit board, but I wasn't to sure of that. It's one of the newest of the Dunlop reissues by the way. Thanks for your time!
 
Re: Help me mod my Fuzz Face? Please.

this is not your typical effect pedal modding forum. if you want some more help, you would have more luck joining a forum based around modding/building pedals. like diystompboxes.com
 
Re: Help me mod my Fuzz Face? Please.

cream123 said:
this is not your typical effect pedal modding forum. if you want some more help, you would have more luck joining a forum based around modding/building pedals. like diystompboxes.com
Click to expand...

See my post in the "isolated outlets" thread. Dying batteries, or a sag setting, willl work wonders for a Fuzz Face.
 
Re: Help me mod my Fuzz Face? Please.

cream123 said:
this is not your typical effect pedal modding forum. if you want some more help, you would have more luck joining a forum based around modding/building pedals. like diystompboxes.com
Click to expand...

Oh. Thanks!
 
Re: Help me mod my Fuzz Face? Please.

the guy who invented fire said:
What do you want to do to it?

Also, you guys really should just run Fuzz Face pedals with batteries...cheep ones at that!
Click to expand...

I'm hoping to widen the range of the fuzz control and raise the output. I have the resistors that I want to use, I just don't know which resistors to remove, and then replace what was there with the resistors that I have.
 
Re: Help me mod my Fuzz Face? Please.

Onslow said:
I bought a thing of 1k-ohm resistors for the output and a thing of 10k-ohm resistors for the trim pot bias. Trouble is, I can't find the website I was going by and I have no idea exactly which ones I'm supposed to remove and replace on the circuit board for the ouput and trim. I tried to follow the paths on the circuit board, but I wasn't to sure of that. It's one of the newest of the Dunlop reissues by the way. Thanks for your time!
Click to expand...

this might help:

http://www.geofex.com/Article_Folders/fuzzface/fffram.htm
 
You must log in or register to reply here.
Back
Top