Help with Single Coil CS69 and and Humbucker SH4 in HSS config

[Hsv]

Hi all,

I am struggling to find a diagram on a few bits of info on how to wire a HSS config with:

- CS69 in neck and middle
- S-Duncan JB SH4 Bridge with COIL TAP
- 1 volume
- 1 tone
- kill switch (on off switch)
- treble bleed mod on neck


So I would pleaseeeee, like to know

- what pots to use (250k / 500k),
- which additional resistors / capacitors needed for treble bleed mod
- an actual schematic of the wiring set up (i'm really hoping its out there already, i can't expect anyone to draw this out!).
- should i worry about volume differences between the three pickups? mostly the bridge being louder than the rest?

I'm revamping a Michael Kelly 1967 as not a fan of the current sound, but it's an amazing guitar.

Thank you in advance!!

 

[Mincer]

Re: Help with Single Coil CS69 and and Humbucker SH4 in HSS config

I use 500k pots, with HSS. Also ours and Fender's pickups are out of phase (FYI).

 

[Hsv]

Re: Help with Single Coil CS69 and and Humbucker SH4 in HSS config

I use 500k pots, with HSS. Also ours and Fender's pickups are out of phase (FYI).

thank you ver much for your reply!

any ideas on a warring diagram ? i have just realised that even though it says 'single sized hum' this wiring diagram might be the exact thing i need minus the coil tap (and minus kill switch), would i be correct?

http://www.seymourduncan.com/wiring...ups,neck-s,middle-s,bridge-h,1-volume,1-tone#

 

[Mincer]

Re: Help with Single Coil CS69 and and Humbucker SH4 in HSS config

That looks like it to me. You can combine it with a diagram that adds a coil cut switch (like on a push/pull).