Is this possible? SuperD + Prails

W

Willybomb

New member
Thinking I might do something different with my lesocaster which is currently SuperD/HFH/3way toggle/V/T.

I would get a new plate from stewmac - HH,VTT and stick a P-Rails in the neck. Imo, about the only way to run a humbucker in the bridge is wide open and flat out, but I like a variety of neck tones, so I would like to get the following, or similar. Do I need a superswitch or can it be done on a conventional 5-way:

1. Bridge, SuperD in series.
2. One coil from the SuperD, and probably the single rail from the P-Rail, probably in series
3. Neck rail only
4. Neck P-90 only
5. P-Rail in series.

As far as the pots go, I'd like to wire it as VV, master T.

Opinions, objections, suggestions? Anyone want to do a diagram?

Thanks,
Willy.
 
Re: Is this possible? SuperD + Prails

You could do that with a Superswitch for sure, but I can't draw a diagram for you. You could do it with a megaswitch (see stewmac.com) which would be simpler, but you'd probably have to swap positions 4 and 5.

I don't think it's doable on a conventional 5-way switch. Definitely not in the order you have, and maybe not 1-2-3-5-4, either, because of the series routings. But I'm no expert.
 
You must log in or register to reply here.
Back
Top