Modified broad caster blend wiring?

['59]

I'm going off of these two wirings:





My wiring should be 1- neck, 2- bridge with neck blend, 3- bridge with Arlo mod.

I had assumed the easy way to do it would be to swap the neck and bridge hot leads, replace the .05 cap with the Arlo RC network, and then install the switch upside down, but now I'm confused.

What is the point of the 15k resistor?

 

[Chistopher]

I believe for your purposes you can just replace it with a jumper. It's part of the corner frequency for the dark setting, and it limits the amount of neck that shows up in the blend position.

What you propose to do sounds correct