Musicman SMB-4a in parallel/series/split

  • Thread starter Thread starter roboscott
  • Start date Start date
R

roboscott

Guest
Hey:)
I am receiving an active preamp (Aguilar OBP-1) this week for my bass and i was wondering if there was a way to hook up a single Basslines MM SMB-4a pickup in parallel/series/split with a 3 way toggle switch? i did see something about doing it with a 3 way blade switch, but i would like to use the toggle because it would fit on my jack plate with no problem and I'm confused about the translation from 3 way blade switch to 3 way toggle and if this configuration can even be done. ( My mm pickup is 2 coil). I am confident with pickup swapping/ soldering, but I'm not sure about this configuration. Could someone explain a simple wiring diagram to do this?
Thanks So much!
 

Attachments

  • 3ws_trans.jpg
    3ws_trans.jpg
    58.3 KB · Views: 0
Last edited:
Re: Musicman SMB-4a in parallel/series/split

The diagrams that you have posted are all for three-way pickup selection purposes.

Look in the Support section. There is a Series/single/parallel switch diagram amongst the Humbucker list.
 
Re: Musicman SMB-4a in parallel/series/split

Three posts and he's already started an Ignore List.
 
Re: Musicman SMB-4a in parallel/series/split

I don't understand what you mean by the ignore list. is that supposed to be some duche baggy statement or something?
I was just looking for some help with some wiring, that's all.
 
You must log in or register to reply here.
Back
Top