Need some help with a wiring diagram!

[frpax]

Hi all!

I've got a project that I'm knee deep in and I was wondering if anyone can give me a hand.

This project is an offset guitar with a pretty unique wiring setup.



The pickups will be:
Bridge: Duncan JB
Middle: Single sized Hot Rails humbucker
Neck: Filtertron

On the bass side of each pickup, will be a roller volume pot. In the upper horn area, will be a 2-way Master On/Off slider switch. (Jazzmaster-esque)

Below (treble side) of each pickup will be:
Bridge (JB): 3-way slider - Coil tap/OFF/full humbucker
Middle (Hot Rails): 2-way slider - On/Off
Neck (Filtertron): 3-way slider - Coil tap/OFF/full humbucker

I'm planning on 1 meg mini pots with Jazzmaster roller knobs on the volume pots.
I'm thinking 500K push/pull tone pots (for bridge and neck). Pull to actuate phase reversal.
Middle tone pot will be regular sized, normal 500K pot.
All tone caps will be .022uF

ANY ideas? ANY AND ALL HELP IS GREATLY APPRECIATED!

 

[frpax]

Re: Need some help with a wiring diagram!

Anyone? Anyone? Bueller?

 

[beaubrummels]

Re: Need some help with a wiring diagram!

You didn't post the diagram you need help with. Or are you asking someone to spend hours making you that complex wiring schematic for free? Some of what you are asking I don't believe will work, like the 3-way slider that is a coil split, humbucker and kill switch in one.

 

[frpax]

Re: Need some help with a wiring diagram!

You didn't post the diagram you need help with. Or are you asking someone to spend hours making you that complex wiring schematic for free? Some of what you are asking I don't believe will work, like the 3-way slider that is a coil split, humbucker and kill switch in one.

No, I'm not asking someone to devote HOURS to custom design a whole wiring diagram for me for free.

I'm just asking for some help. Point me in the right direction; refer me to a website where I can better understand how pot values affect various things; etc.

 

[Artie]

Re: Need some help with a wiring diagram!

No, I'm not asking someone to devote HOURS to custom design a whole wiring diagram for me for free.

I'm just asking for some help. Point me in the right direction; refer me to a website where I can better understand how pot values affect various things; etc.

I can cover this. But just now, I'm getting over the cold/flu from hell. Gimme some time. I'll see what I can doodle up.

 

[Darg1911]

Re: Need some help with a wiring diagram!

I can cover this. But just now, I'm getting over the cold/flu from hell. Gimme some time. I'll see what I can doodle up.

What a guy!

Just got over one about a month ago. First time I've been cold/flu sick in well over a decade. Sucked. Get better.

 

[frpax]

Re: Need some help with a wiring diagram!

I can cover this. But just now, I'm getting over the cold/flu from hell. Gimme some time. I'll see what I can doodle up.

YOU DA MAN!


We're also rethinking and (hopefully) trying to simplify the wiring. I'll PM you what our scatterbrains are thinking.