P-Rail Wiring Question

[Fito-Fuentes]

Hello,
I'm new to this forum so please excuse my poor english and if this is not the right place for my thread/question.
I´m looking for some help regarding the wiring for a SD P-Rails at the Bridge and a SD SL59 in the neck position. 1 Volume and 1 Tone, 5 way lever switch. It 's a for a Yamaha Pacifica 510V wich is modded for a mini neck humbucker .
I want to wire them as follows:
1. Neck HB serial
2. Rail + Neck HB split (South)
3. Rail
4. P-90
5. HB serial
I have tried several wirings with a Eyb 5 way megaswitch M, but I cannot get it to work probably. So now i'm wodering if this wiring layout is possible with only a 5 Way megaswitch. Your help would be so much apreciated since i get slightly mad because it does not work :15:. Can you help me with a wiring Diagramm?
Thanks in advance
Rockin Greetz
Fito

 

[BriGuy1968]

Re: P-Rail Wiring Question

Hi Fito-Fuentes, and welcome to the forum!

I was intrigued by your request, and I had a little time, so I sat down and came up with the diagram below.

Please note that I reversed your numbering to more easily match up to the switch since the lever points in the opposite direction from the numbers for the terminals.

I'm pretty sure this will work for you, but perhaps some of our fellow forumites could take a look and verify. I hope it helps!

[emoji450]Sent from my iPhone using Tapatalk [emoji441]