PopinFRESH
New member
Hey guys, I'm trying to figure out if I have this wiring correct. With P-Rails using 2 on/off/on mini toggles for selecting the P90, Series humbucker, or rail, then using the 3 way LP pup selector switch to a Master vol & master tone. I'm curious about the grounding shown on the diagram for this with 2 vol, 2 tone, 2 mini toggles. It doesn't show the 2 mini toggles casing being grounded like the pot's? As far as I can tell, I would wire from the P-Rails to the mini toggles with the red & white on the middle lug and the black on the lug with the output and the green on the lug going to ground. Also should I solder the bare wire directly to the ground on the vol pot so the pup's back plate is always grounded? From the out put of the 2 mini toggles I'd wire to the 3 way LP toggle switch and from it's output wire to the input lug on the master vol pot and from the ground on the 3 way to the vol pot case. then from the output of the vol pot to the hot tip of the out put jack.? if someone can double check my wiring logic I'd really appreciate it!