72 Telecaster Custom (Bridge single/Neck Humbucker 2 vol 2 tone)
I have installed a Jazz Humbucker in the Neck a few weeks agao and have an old single in the bridge that is about to be replaced with a Jerry Donahue. While I have it apart I want to try and find a solution to a problem.
Whenever I am playing with both pickups if I turn the Humbucker vol down it doesn't do anything till about 8 then it is like a switch and I just get full bridge pickup. When just running the neck it works just fine. Bridge pot is 250K Fender and Neck is 500K Gibson.
Also I noted when I was installing the Humbucker a while back that my tone pot have two of the legs connected. The middle and one side with the pickup attached to the otherside. Is this normal?
Thanks hope to have a solution before I start to install the JD this weekend.
I have installed a Jazz Humbucker in the Neck a few weeks agao and have an old single in the bridge that is about to be replaced with a Jerry Donahue. While I have it apart I want to try and find a solution to a problem.
Whenever I am playing with both pickups if I turn the Humbucker vol down it doesn't do anything till about 8 then it is like a switch and I just get full bridge pickup. When just running the neck it works just fine. Bridge pot is 250K Fender and Neck is 500K Gibson.
Also I noted when I was installing the Humbucker a while back that my tone pot have two of the legs connected. The middle and one side with the pickup attached to the otherside. Is this normal?
Thanks hope to have a solution before I start to install the JD this weekend.