ghostraineverstops
New member
Hi, I began this projexct a bit over a year ago, the plan was to fill all the chips on the corners and repaint it, so I did that and it had a lot of thick plastic polyurethane over the wood so it took this long to get it off and i finally embraced the wood enough to paint it matte black and leave the grain out. lol. Well I cut the pickups out and left the cables in but im sure I should have taken them off the pots, but I'm new to this. This is the hard part of my project but I have a diagram. I just need someone to help me pull this off right the first time. It's 2 humbuckers and a killswitch with 2 functions one regular, and then in reverse with a volume push/pull that when the push/pull pot is pulled it only then opens the signal back up with the momentary switch pressed. I have a soldering iron, and the push pull but I need to buy some cables for the switch, and some type of hot passive pickups for it I have in mind many, but I just need to know how it will all be wired as it's my first wiring job and maybe what kind of wires. This is where I got the wiring and idea from: https://www.youtube.com/watch?v=WbEyxDbHYzc So anyone that chimes with advice thanks a lot in advance, id be thrilled to have this done by the next week or 2.
nder:
Last edited: