I have strat pickguard with the Brian May 6 switch pickguard mod
I have neck single coil with middle single coil
heres where it gets hairy..........
The bridge pickup is a stacked 4 wire tapable SD pick up with a push pull to go split or full humbucker.
Everything is wired and ready except one of the 6 switches that goes to the humbucker is acting like a master switch.
I think if there was a schematic to tie the push pull switch into the last one of the 6 switches I might be able to seperate and control the signal to the humbucker.
I really need a schematic for the push pull??????
Anyone know if a schematic exist???????
I'm lost
HEEEEEELP............AND THANK YOU
Drycreek
I have neck single coil with middle single coil
heres where it gets hairy..........
The bridge pickup is a stacked 4 wire tapable SD pick up with a push pull to go split or full humbucker.
Everything is wired and ready except one of the 6 switches that goes to the humbucker is acting like a master switch.
I think if there was a schematic to tie the push pull switch into the last one of the 6 switches I might be able to seperate and control the signal to the humbucker.
I really need a schematic for the push pull??????
Anyone know if a schematic exist???????
I'm lost
HEEEEEELP............AND THANK YOU
Drycreek
