Quick question about a diagram and wire used..

[LogicallyInsane]

Planning to use this diagram..
http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=2ts_2v_2t_phsp

Okay.. already have the triple shots installed, and have purchased the pots, caps etc..

My question is simple.. What style wire would be best for this particular project?
Should I get the vintage single conductor type with the metal outer shielding, vintage cloth type with single conductor, or should I get some 2 conductor shielded wiring?

I know either could probably work, but I'm OCD and don't know which is best for this project.. lol

 

[DreX]

Re: Quick question about a diagram and wire used..

I like using cloth wire when the pickups are also cloth wire, otherwise this is good stuff. There might be some benefit to shielded wires, but I'd make sure its fully insulated and not exposed shielding, otherwise the shielding can brush up against positive solder points and short out the whole thing. I don't think it's worth the hassle personally, especially if you're dealing with push/pulls, it will get crowded.