Simple Telecaster wiring question.

Stonefoot

New member
I would like to rewire my Tele's tone knob to affect neck pickup only, how would I have to alter this schematic to achieve that? Thanks in advance!

tele_1hum_1sing.jpg
 
Re: Simple Telecaster wiring question.

See the terminal on the volume pot that the tone control and also the output of the switch are both soldered to? Unsolder the connection that goes to the tone control, replace that wire with a wire long enough to solder it to same terminal on the 3 way switch as the neck pickup is soldered to. Lew
 
Re: Simple Telecaster wiring question.

See the terminal on the volume pot that the tone control and also the output of the switch are both soldered to? Unsolder the connection that goes to the tone control, replace that wire with a wire long enough to solder it to same terminal on the 3 way switch as the neck pickup is soldered to. Lew

That would work assuming you wanted the tone control to also work with the switch in the middle position.

I assumed neck pickup position only without the middle with this diagram.

EDIT: if you wanted bridge pickup only switch the red wire that leads to the tone control to the empty lug on the other side of the switch.


tele-neck-tone-only.jpg
 
Last edited:
Re: Simple Telecaster wiring question.

That would work assuming you wanted the tone control to also work with the switch in the middle position.

I assumed neck pickup position only without the middle with this diagram.

EDIT: if you wanted bridge pickup only switch the red wire that leads to the tone control to the empty lug on the other side of the switch.

Heh, now I'm getting confused. What I was after was bridge pickup's tone control fully bypassed in every switch position and neck pickup's tone control usable in every switch position. So bridge's tone always maxed out. :eyecrazy:
 
Re: Simple Telecaster wiring question.

Heh, now I'm getting confused. What I was after was bridge pickup's tone control fully bypassed in every switch position and neck pickup's tone control usable in every switch position. So bridge's tone always maxed out. :eyecrazy:

Then do it my way... :laugh2: Lew
 
Re: Simple Telecaster wiring question.

Your way being... hmmm... this way?


Yeah...I think so! That way the tone control is connected to the neck pickup and disconnected from the bridge pickup...although when the pickups are combined the tone control will probably roll off treble from both pickups.

Lew
 
Re: Simple Telecaster wiring question.

Yeah...I think so! That way the tone control is connected to the neck pickup and disconnected from the bridge pickup...although when the pickups are combined the tone control will probably roll off treble from both pickups.

Lew

Cool! Thanks for your help, this improvement will undoubtedly enhance my playing experience by 1000%! :banana:
 
Back
Top