Soldering up a DPDT Pushbutton switch,... proper orientation

G

gregggyf

New member
Good Afternoon,

I am planning to start a mod that involves the use of a DPDT pushbutton switch and I do not know which end is up.

So, I was wondering if there would be a major problem if the switches were wired "possibly" upside down.

The mod I will be performing is this one listed below, and this mod involves two DPDT pushbutton switches.

Any help I could get would be greatly appreciated.

Thank you again.

Greg


http://www.seymourduncan.com/suppor...ics.php?schematic=series_spl_parallel-w-phase
 
Re: Soldering up a DPDT Pushbutton switch,... proper orientation

There wouldn't be a problem. It just changes which direction the switch has to toggle to get the affect.
 
You must log in or register to reply here.
Back
Top