Suggestions for a new power supply.

man-in-moon

man-in-moon

New member
I need a new power supply for the board I am doing. I need a good bit of out puts. I don’t plan on doing a big board but I rather have the extra power and not need it than end up needing it later on and not having it.
I also need some 12 and 18 volt outputs as well. So far my main choices are cioks and the true tone 1-spot pro 12.
who has experience with either of these brands? Any pros and cons to either.
 
I use an MXR ISO-Brick for that. It has a couple 18v and a couple where you can vary the output. What uses 12v exactly? Looks like the 1 Spot has 12v, and Strymon has a power supply with 12v

11238000001.BOTT__71669.1576897888.jpg
 
Last edited:
beaubrummels said:
I use an MXR ISO-Brick for that. It has a couple 18v and a couple where you can vary the output. What uses 12v exactly? Looks like the 1 Spot has 12v, and Strymon has a power supply with 12v

11238000001.BOTT__71669.1576897888.jpg
Click to expand...

I grabbed one of these recently for the same reason - flexibility in power options. Haven't used the variable settings much, but it worked fine when testing my vocal processor that takes 12v.
 
I picked up a cheap Chinese one from Amazon supposed to arrive Tuesday.. it has I think 10 outputs, 9,12,18. I'll let you know how it goes. It was only 30 bucks
 
I’ve been looking for a while at power supplies; I have a cheap Donner one, but figured I might get something better.
The One Spot CS12 has been on my radar for ages, especially as it can run a Whammy 4 with the 9v AC output. But then I replaced it with a Whammy DT, so that’s not an issue.
The Rockboard ISO Power Block V16 is another one I’ve been looking at, along with the Palmer Universal Power Supply PWT12. Unfortunately I don’t have experience of either.
 
You must log in or register to reply here.
Back
Top