Artie
Peaveyologist
. . . at least in this specific case. 
I finally got around to swapping out the C5 in my Genny, for a tremspaced C5 that I got from Lew. (Thanks Lew.) I've been fighting a problem with the high E string, (high pitch, that is), having a significantly lower volume than the other strings. The pole pieces for the two E strings were actually inside the strings themselves. The tremspaced lines up perfectly, and the string imbalance is now gone. So, in this case, it did matter.
And on a little sidenote . . . when you hurry a job - you make mistakes.
I was anxious to hear how this sounded, and I got sloppy. I used a Tone push/pull so I could run the C5 in parallel. After I got it together, both switch positions sounded the same, and neither sounded like a humbucker. A quick examination revealed two separate problems - one which masked the other.
1. Because I had the Tele plate upside down, I put the red wire on the wrong terminal, which meant that in series, the pickup should have gone dead.
2. When I put everything back together, the "bare" wire touched up against the red wire terminal, placing the pup in a state of constant "split", in either switch position.
Thanks goodness it was a Tele, with separate control plate. Problem solved, and now it sounds great.
Artie
btw - I'll reserve judgement on how well I like the parallel sound. Its too soon to say for sure. It definitely didn't just jump out and grab me.
I finally got around to swapping out the C5 in my Genny, for a tremspaced C5 that I got from Lew. (Thanks Lew.) I've been fighting a problem with the high E string, (high pitch, that is), having a significantly lower volume than the other strings. The pole pieces for the two E strings were actually inside the strings themselves. The tremspaced lines up perfectly, and the string imbalance is now gone. So, in this case, it did matter.
And on a little sidenote . . . when you hurry a job - you make mistakes.
I was anxious to hear how this sounded, and I got sloppy. I used a Tone push/pull so I could run the C5 in parallel. After I got it together, both switch positions sounded the same, and neither sounded like a humbucker. A quick examination revealed two separate problems - one which masked the other.
1. Because I had the Tele plate upside down, I put the red wire on the wrong terminal, which meant that in series, the pickup should have gone dead.
2. When I put everything back together, the "bare" wire touched up against the red wire terminal, placing the pup in a state of constant "split", in either switch position.
Thanks goodness it was a Tele, with separate control plate. Problem solved, and now it sounds great.
Artie
btw - I'll reserve judgement on how well I like the parallel sound. Its too soon to say for sure. It definitely didn't just jump out and grab me.