ehdwuld
A Ficus
ok
ya'll might remember the Daphne blue strat
that I put the INF pickups in
heres an update:
I got cold feet on the roller nut exchange, but....
finally rolled the magnet in the neck pickup
phase problems went away
dropped the wiring out under the pickguard to make pickup tests easier
pics are a bit dark, sorry
here you can see the white is the humbucker start for the INF3 neck
the fat red is the wire from the neck pickup
the blacks are ground leads
and the unattached red wire in all photos is the coil tap from the INF3
here full unmodified pickup
(you can see the resistor dangling from the ground
and a shot with the meter on it showing 12k wind
now here you can see when I connected the resistor
how the reading across the coils changed (20k resistor from radio shack)
and here is a close up albeit a bit dark
I'll try to get some clips up this week
but right now the lower resistance seems to have softened the pickup a bit
it still is loud but some of the mush is gone
I didnt "Air" the pickup out as I had planned
the "slugg" poles ? the slightly smaller hex poles on the top of the INF
started to fall out
just sloppin round in there
my guess the wax that was holding them in place finally came loose
i supose I will have to warm em up to get the wax reseat em
I dunno
ya'll might remember the Daphne blue strat
that I put the INF pickups in
heres an update:
I got cold feet on the roller nut exchange, but....
finally rolled the magnet in the neck pickup
phase problems went away
dropped the wiring out under the pickguard to make pickup tests easier
pics are a bit dark, sorry
here you can see the white is the humbucker start for the INF3 neck
the fat red is the wire from the neck pickup
the blacks are ground leads
and the unattached red wire in all photos is the coil tap from the INF3
here full unmodified pickup
(you can see the resistor dangling from the ground
and a shot with the meter on it showing 12k wind
now here you can see when I connected the resistor
how the reading across the coils changed (20k resistor from radio shack)
and here is a close up albeit a bit dark
I'll try to get some clips up this week
but right now the lower resistance seems to have softened the pickup a bit
it still is loud but some of the mush is gone
I didnt "Air" the pickup out as I had planned
the "slugg" poles ? the slightly smaller hex poles on the top of the INF
started to fall out
just sloppin round in there
my guess the wax that was holding them in place finally came loose
i supose I will have to warm em up to get the wax reseat em
I dunno