Hey, I was needing some basic information on how to wire a 12 position varitone. Do I connect a 10M resisistor to each position then add a cap to each one of the 10M resistors individually? And then does the single pole get connected to ground and the caps to hot or is it the other way around? And where the heck does the inductor go and where can I get one?
According to this diagram I would have the caps in parallel go to hot and the pole to ground. But I'm not sure where the inductor goes.
According to this diagram I would have the caps in parallel go to hot and the pole to ground. But I'm not sure where the inductor goes.