What did I do wrong when I tried to connect to my POD xt and strobostomp??

S

Sorg

New member
This is what I did: guitar -> peterson strobostom in - strobostomp out -> pod xt input - pod xt output -> Input on amp.

I only got a lot of noise/feedback and 0 sound. Then I removed the Strobostomp and did this: guitar > pod xt input - pod xt output -> Input on amp.

Problem solved. Somebody who knows what I did wrong? Wrong setup on the Strobostomp? Unfortunately I don't have the manual here..

ANd the cables were all fine.
 
Re: What did I do wrong when I tried to connect to my POD xt and strobostomp??

Sorg said:
This is what I did: guitar -> peterson strobostom in - strobostomp out -> pod xt input - pod xt output -> Input on amp.

I only got a lot of noise/feedback and 0 sound. Then I removed the Strobostomp and did this: guitar > pod xt input - pod xt output -> Input on amp.

Problem solved. Somebody who knows what I did wrong? Wrong setup on the Strobostomp? Unfortunately I don't have the manual here..

ANd the cables were all fine.
Click to expand...

somethin with D.I settings?
 
Re: What did I do wrong when I tried to connect to my POD xt and strobostomp??

You can download a .pdf manual from Peterson.
http://www.petersontuners.com/support/pdfmanuals/index.cfm

Did you try going just into the tuner, then into the amp?
The tuner is supposed to be true bypass, did you try the original hookup with the tuner in and out of the chain via the footswitch?
Does the tuner work with other pedals?
Do other pedals have the same problem working with the Pod?
 
Re: What did I do wrong when I tried to connect to my POD xt and strobostomp??

- Yes it works to use the strobostomp alone.
- I have previously uses the POD xt together with a Crybaby Wah Wah without problems.
 
Re: What did I do wrong when I tried to connect to my POD xt and strobostomp??

you have to adjust one of those little switches on the peterson to allow true bypass ... if you do not, nothing comes out of the peterson ... it's just a 'dead end' for tuning unless you change the setting

it's in the manual

t4d
 
Re: What did I do wrong when I tried to connect to my POD xt and strobostomp??

When I checked it both switches were on/faces down. I put the 2 up and only have 1 down now. Is that correct?
 
You must log in or register to reply here.
Back
Top