Andrew Lamprecht
Minion of One
It's a Japanese strat made in 2006. I have 1 spare arm here, its the GFS one I used in my Squier (GFS bridge) and that is too small.
What size trem arm would my strat need? (Fender Japan)
- Thread starter Andrew Lamprecht
- Start date
Rand-O-Monium
New member
Re: What size trem arm would my strat need? (Fender Japan)
Maybe check GC,they usually have a drawer full...
No specifics,tho,sorry.
Maybe check GC,they usually have a drawer full...
No specifics,tho,sorry.
Vasshu the humanoid typhoon
Unseen
Re: What size trem arm would my strat need? (Fender Japan)
Most vib arms uses mm threading on most MIJ stuff
Most vib arms uses mm threading on most MIJ stuff
ehdwuld
A Ficus
Re: What size trem arm would my strat need? (Fender Japan)
i would think it would be 6mm
but I could be wrong
take it to the hardware store
start with the 10-32 screws (thats probably what you GFS arm is)
see if it threads in
then each size till they wont fit in
then the drawer with the metrics
one of the standards will almost fit but will have a lot of slop
or vice versa
one of the metrics will be almost there
dont try to tighten any thing tighter than what you fingers can muster
i would think it would be 6mm
but I could be wrong
take it to the hardware store
start with the 10-32 screws (thats probably what you GFS arm is)
see if it threads in
then each size till they wont fit in
then the drawer with the metrics
one of the standards will almost fit but will have a lot of slop
or vice versa
one of the metrics will be almost there
dont try to tighten any thing tighter than what you fingers can muster
