Why my neck of stock humbucker of Ibanez RX 180 Japan sounds thin and weak?

[rockartlml]

I followed these wiring diagram on the below of this topic but the neck sounds still thin and weak while the bridge sounds full. Both of the stock pickups are 3 conductor wiring. Red, white and bare wire. Red is my north and the white i think for split while bare wire is for ground. The components I use are CRL 5 way sliding switch, WD vol and tone pot 500k each and H-S-H configuration. Can you all please help me how to find this out the neck will sound full? Thanks

http://teamninjaz.me/ibanez-wiring-diagram.html/wiring-diagram-ibanez-s420-gio-apoint-co-in

https://www.bareknucklepickups.co.uk/upload/support/1_f9c7c2a.pdf

 

[RockinProf]

Re: Why my neck of stock humbucker of Ibanez RX 180 Japan sounds thin and weak?

I'm thinking that you have a couple of potential issues going on here. To give the best advice, how is your bridge humbucker wired? Is it, bare to ground(typically back of the volume pot), red to a lug facing away and the white on a lug facing inward? Or is the bare wire and the white wire both soldered to the back of the pot with just one wire going to the five way?

 

[Adieu]

Re: Why my neck of stock humbucker of Ibanez RX 180 Japan sounds thin and weak?

Extremely weak (like 10x weaker) or just disappointing?

Extremely weak = wiring issues
Disappointing = set too low from strings and/or just sucks and/or only running one coil