Wiring diagram help: Duncans w/ multi-pole 5-way...

[Despised]

Hello again all. I need some help with a couple of diagrams. One is for an H/H configuration with the inner coil (bridge neck side coil & neck bridge side coil) split in position 2 and outer coil (bridge bridge side coil & neck neck side coil) split in position 4. The problem I'm having is that in position 2 I am getting both neck side coils on & position 4 I am getting both bridge side coils on... Can someone inform.me of which wires to switch and where so I can get the correct coil splits in tbe right positions?
(And no, flipping/rotating the pickup is not an option... it looks gaff AF with the SD logo flipped upside down and backwards...)

The second diagram I need help with is an HSH configuration, but this time it's gonna be bridge in parallel in position 2 & neck in parallel in position 4... I haven't done this one yet, because I am automatically expecting an issue with the wiring based on the current problem I am having with the H/H configuration one already...

I've attached both diagrams below, and have already converted the wiring colors from DiMarzio to Duncan - or what thier supposed to be anyway...

So can anyone help me out by:
*Letting me know which wires to swap and where on the H/H diagram to get the correct coil split configuration?
*And either let me know if the HSH diagram is correct, or which wires need to be swapped where to get that one correct as well?

Thanks in advanced, as usual everybody.

 

[Mincer]

For question 1, did you flip the magnet on one of the pickups?
This thread may help.

 

[Despised]

For question 1, did you flip the magnet on one of the pickups?
This thread may help.

It is not. I'm using a standard production model Distortion 7/Jazz 7 set. But I'm going thru the thread now to see what I can dig up from it. My only concern at this one is that your neck pickup is an actual RWRP while mine isn't....

 

[Despised]

So what I'm looking to get - which is supposed to be - is this coil configuration in the first pic. What I'm actually getting is what's in the 2nd one...

 

[ehdwuld]

On the bridge pickup

Substitute the black abd green for the red/white pair
use the red as hot or black
use the white as ground , usually green

It doesnt change the polarity of the pickup
Dont mess with magnets or anything

It just changes which coild is split to