Wiring for P-rails in a tele style build with triple shots and push/pull

R

Ronzone

New member
Rookie builder here- installing p-rails with triple shots into an HH tele style body with a regular control plate- 3 way switch, push/pull vol, tone. I need help with the wiring scheme and I can't figure out the right one to use on the diagrams page. Ultimately I'd like to have all three coils working independently on each p'cup which I think the regular triple shot diagram does, but I can't figure out how and where to wire the push /pull pots to get in/out of phase and series/parallel. Help!
 
Re: Wiring for P-rails in a tele style build with triple shots and push/pull

Do not need the push/pulls. The triple shots give you those options as well as coil selection.
 
Re: Wiring for P-rails in a tele style build with triple shots and push/pull

Thanks very much for the reply. I didn't realize I could affect the phase and get anything but series on the humbucker mode. Will try it out.
 
You must log in or register to reply here.
Back
Top