Wiring help for my "Franken-Paul" project.

[makeuacaster]

What I have: 2 Pearly Gates, 2 vol. push/pull pots, 1 tone push/pull pot. No switch. (I also have 2 Triple Shots I could use)
What I want: I'd like to use the p/p vol. pots to switch series/parallel and the tone for a master coil tap. I can't find anything on Duncan's site or searching the web that works. Can it even be done?
If so (or close to it) can I get a wiring diagram from one of ya's.
What got me started was a project where I used 2 P-Rails with Triple Shot rings and can't put that guitar down! So I got to thinking (my wife says that's always trouble) why not work up some tonal variations in this project since I already have the parts!

 

[oilpit]

Re: Wiring help for my "Franken-Paul" project.

I'm far from a wiring expert but if I were to guess I would think a Jimmy Page wiring diagram would be a good starting point

https://www.siglermusiconline.com/pages/diagrams-les-paul-jimmy-page

 

[makeuacaster]

Re: Wiring help for my "Franken-Paul" project.

Yeah I saw that, in fact bought one of their pre-wired sets a while ago. But it only has one tone and the Vol pots/switches coil tap instead of switching series/parallel. Ill probly have to work around that and just experiment with one tone pot. Thanks for the reminder.

 

[oilpit]

Re: Wiring help for my "Franken-Paul" project.

Ill probly have to work around that and just experiment with one tone pot. Thanks for the reminder.

No problem! Wish I could be more help, but I don’t think it’ll be too hard to achieve. I’ll do some googling if I have any down time at work and see if I can find something closer to what you’re looking for and hopefully there are some more knowledgeable members can beat me to the punch!