I am working on a project and I have a slash humbucker and a alnioc pro 2. The slash is a single conductor and the other is a 4 conductor. I am looking to wire them to 2v1t push pull coil split. I guess I can split the alnico and wire it in series. There is also a 3 way toggle switch. How would I go about doing this project? I know I cant split the slash humbucker,should I not use a push pull for that humbucker? How would I wire it all together. I dont see anything on the site that tells me how to do it. I am using 3 push pull pots. Should I just wire the alnico with the 2 push pull pots and use a regular pot for the slash?
wiring pick ups
- Thread starter MusicBill
- Start date
Re: wiring pick ups
You only need one p/p pot...to split the A2 Pro. Use regular pot for the Slash vol pot and the master tone pot. Use this diagram for the A2P but instead of going to the jack, you'd go to the switch.
https://docs.google.com/gview?embed.../wp-content/uploads/2016/05/1H_1VppSPL_1T.pdf
Or just use this diagram and ignore the red and white wires of one of the pups (Slash) going to the p/p.
https://docs.google.com/gview?embed...-content/uploads/2016/05/2H_3G_2V_1TppSPL.pdf
You only need one p/p pot...to split the A2 Pro. Use regular pot for the Slash vol pot and the master tone pot. Use this diagram for the A2P but instead of going to the jack, you'd go to the switch.
https://docs.google.com/gview?embed.../wp-content/uploads/2016/05/1H_1VppSPL_1T.pdf
Or just use this diagram and ignore the red and white wires of one of the pups (Slash) going to the p/p.
https://docs.google.com/gview?embed...-content/uploads/2016/05/2H_3G_2V_1TppSPL.pdf
Last edited:
eclecticsynergy
Well-known member
Re: wiring pick ups
Yes. The tone pot takes signal straight off the master volume pot, so it will still affect both.
Yes. The tone pot takes signal straight off the master volume pot, so it will still affect both.
