Wiring Schematic Help

[Greg Chapman]

Greetings folks. I have a Strat with a slightly unusual Mosrite kind of flavour due to both of the PUPs being non-strat and slanted off centre in the pickguard. Anyway, I'm having problems finding a wiring diagram to meet my needs, which really aren't that kinky;

S0 - 2 single coils, 2 independent volumes and one tone on a DPDT push-pull switch offering the option of Series operation. It has a 3 position traditional Tele-style lever selector and that's it. I've already reduced my life expectancy by a good number of years following the completion of beautifully soldered circuits that would look utterly wrongheaded to an electronics buff but seemed sound to me on paper. I REFUSE to take this to a tech as I'm sure I'm just a joint or two away, so to speak...

Any assistance would be marvelous!

Cheers,

Greg.

 

[Artie]

Re: Wiring Schematic Help

Welcome to the forum. The basic switching is like this.



The neck and bridge wires just go to wherever they go now.

Note: When I first drew this up, it was for master vol/tone. It won't matter which position your 3-way is in, but both volume controls will be active. To eliminate that loading, simply omit the connection that goes from the upper-right terminal to the neck hot wire. That means you'll need to have the 3-way in either the N or N/B position, and use the neck vol. But it does remove the extra loading of the bridge vol pot.