Would anyone be willing to help go from schematic to PTP layout?

[gordon_39422]

Hey fellas... I've designed, or rather cloned a few amp components and put them together to make a decent amp. I have built amps before, but was following a layout provided via the internet. I have the schematic complete on LTspice IV. But I've never taken a schematic and gone to PTP from scratch. I know there's more to it than just following the schematic on comp at a time, like star ground, crossing wires at 90*, etc... But I also know proximity to some components cause oscillations and humming. If anyone would be willing to help, I'd greatly appreciate it. Also, when I say PTP, stripboard to point is what I really mean...

The current amp is a "Champ" with a few mods... The preamp is more like a Marshall JCM800 and I have inserted a second preamp tube to drive the passice Tone Stack along with a Cathode Follower, terminating into a 6V6 power tube.

Thanks for your time and assistance,
Gordo

 

[gordon_39422]

Re: Would anyone be willing to help go from schematic to PTP layout?

Bump

I could reallly use some help from the amp gurus, glassman, etc... Just some pointers to keep it quite and free of oscillations...