Long time lurker, I just got a RG120 that was in need of some serious help. I have replaced pickups before, but never really gone much into the modding arena. I'm trying to wire up a Jazz Neck and a Dimebucker Bridge in the following way:
Neck Pickup goes to On/On/On switch to be either Series/Coil Cut (South or Screws)/Parallel. Output from that switch goes to 500k pot for Neck tone. Output from that goes to a 4 way switch.
Bridge pickup goes to On/On/On switch to be either Series/Coil Cut (North or bar farthest from the trem)/Parallel. Output from that switch goes to a 500k pot for Bridge tone. Output from that goes to a 4 way switch.
The 4 way switch should be giving me Bridge/Both Parallel/Neck/Both Series and then sending output to the master volume pot and then to the jack.
The purpose is to be able to do all of the standard humbucker mods, but be able to have that virtual middle humbucker setup too (both series with both humbuckers in coil cut mode).
Do I have this right? Can someone help me move the 4 way switch wiring so that it would go Bridge/Both Parallel/Both Series/Neck?
I'm sorry for the crappy schematic... MSPaint isn't much to work with and I'm not able to take my time, being at work and all
.
Neck Pickup goes to On/On/On switch to be either Series/Coil Cut (South or Screws)/Parallel. Output from that switch goes to 500k pot for Neck tone. Output from that goes to a 4 way switch.
Bridge pickup goes to On/On/On switch to be either Series/Coil Cut (North or bar farthest from the trem)/Parallel. Output from that switch goes to a 500k pot for Bridge tone. Output from that goes to a 4 way switch.
The 4 way switch should be giving me Bridge/Both Parallel/Neck/Both Series and then sending output to the master volume pot and then to the jack.
The purpose is to be able to do all of the standard humbucker mods, but be able to have that virtual middle humbucker setup too (both series with both humbuckers in coil cut mode).
Do I have this right? Can someone help me move the 4 way switch wiring so that it would go Bridge/Both Parallel/Both Series/Neck?
I'm sorry for the crappy schematic... MSPaint isn't much to work with and I'm not able to take my time, being at work and all
![](https://forum.seymourduncan.com/core/images/smilies/cool2.gif)
Comment