I have two SD Humbuckers and have both coils split. But the middle position is not hum canceling. Not sure what to do. I think i have to switch up two of the wires on the mini switch for one humbucker but not sure what.
Announcement
Collapse
No announcement yet.
Two coil split wiring help?
Collapse
X
-
Re: Two coil split wiring help?
I had the same problem with my PG set in a LP. You would soldeer the green and black together to use as your tap line, use white to switch and red to ground (I think).
Note* This post has incorrect information, see post below.Ain't nothin' but a G thang, baby.
-
Re: Two coil split wiring help?
Ok, found it. Red is hot, white is ground, black and green soldered together as tap line. This is all assuming you have one pickup wired normally (black to hot, green to ground, red and white together as tap line).Ain't nothin' but a G thang, baby.
Comment
-
Re: Two coil split wiring help?
Originally posted by Benjy_26Ok, found it. Red is hot, white is ground, black and green soldered together as tap line. This is all assuming you have one pickup wired normally (black to hot, green to ground, red and white together as tap line).
Comment
Comment