Control Plate for a Telecaster

[basguitar]

I have a Fender Blacktop Tele. I want to install the Hot Rodded humbucker set (SH-4& SH-2). what control plate should I use so that I can use the coil tapping with these pickups and still keep the Tele look?

[Evil_Pun]

Re: Control Plate for a Telecaster

Depends on how you want to go about it. You can just get a push pull pot and swap out the tone or volume pot that's on there now following this diagram http://www.seymourduncan.com/support...2hum_2pushpull . you can get a 5 way switch to replace your 3 way switch using this wiring diagram http://www.seymourduncan.com/support...vol_1tone_5way

Those two examples only would require you to buy just one new part and keep your tele looking stock.