Hey guys,
So I'm stumped on how to wire this up. I want to be able to basically mix the signal of two pickups together using seperate volume controls for each (probably tone controls for each in there as well, tied to corresponding volume pot). Simply wiring them to the same output just does not work as it puts them together in a parallel circuit and everything gets crazy at that point. I think I read somewhere that you can do this with an active setup, but not passive. Does that make sense? It kind of does I suppose, I mean mixers do it.
Is a blend pot my only work around?
To sweeten the deal, one pickup is 250k and the other is 500k. How does that interact when sent to the same blend?
Anyway I'd love to hear some ideas from you all.
Thanks so much!
Phil
So I'm stumped on how to wire this up. I want to be able to basically mix the signal of two pickups together using seperate volume controls for each (probably tone controls for each in there as well, tied to corresponding volume pot). Simply wiring them to the same output just does not work as it puts them together in a parallel circuit and everything gets crazy at that point. I think I read somewhere that you can do this with an active setup, but not passive. Does that make sense? It kind of does I suppose, I mean mixers do it.
Is a blend pot my only work around?
To sweeten the deal, one pickup is 250k and the other is 500k. How does that interact when sent to the same blend?
Anyway I'd love to hear some ideas from you all.
Thanks so much!
Phil
Comment