2 tripleshots, 1 vol/1 tone with series/parallel, and phasing schematic

[rodzimguitar68]

I am using the schematic under the triple shot wiring for a 3-way toggle, master vol, master tone, and both pots are push/pull. The volume reverses the phase of the neck pickup, and the tone puts the pickups in series with one another.

http://cdn.seymourduncan.com/pdfs/support/schematics/2ts_1v_1t_phsp.pdf

I also want to do the trick where I reverse the wiring of the bridge tripleshot so the mini-switches work in a logical fashion. Per the tripleshot installation notes, I can solder the pickups wires Green onto the White triple shot harness, White wire to the Green triple shot harness, and the same thing - Black wire onto the Red triple shot harness, and the Red pickup wire onto the Black tripleshot harness spot. The bare wire still goes into the Bare tripleshot spot.

My question is, whether I also need to wire the push pull in reverse from what the schematic shows? The schematic shows the white tripleshot wire going to the 3-way toggle, and the bare and black going to the tone pot push/pull.

Do I need to send the black wire to the 3-way and connect the white wire where the black one is shown to go, because I am doing that trick on the triple shot of swapping the wires?

Thanks

[hermetico]

Re: 2 tripleshots, 1 vol/1 tone with series/parallel, and phasing schematic

Not. You don't need it.