hhhhnnnn39
New member
Hi,
This is my first time on the forum. I would really appreciate if someone could help me with a question about installing a pickup.
I want to install Seymour Duncan JB SH4 Trembucker into the bridge position of my Strat. The middle and neck pickups will remain Fender stock single coils.
My question is, do I need to reverse the hot and ground wires on the SD pickup when I solder it in the guitar?
I'm asking because I know SD pickups have opposite polarity than Fender. I also know that hot and ground wires on SD single coil pickups need to be swapped when combining them with Fender stock ones, but I don't know if that applies to humbuckers as well.
Thanks very much for help and responses in advance.
This is my first time on the forum. I would really appreciate if someone could help me with a question about installing a pickup.
I want to install Seymour Duncan JB SH4 Trembucker into the bridge position of my Strat. The middle and neck pickups will remain Fender stock single coils.
My question is, do I need to reverse the hot and ground wires on the SD pickup when I solder it in the guitar?
I'm asking because I know SD pickups have opposite polarity than Fender. I also know that hot and ground wires on SD single coil pickups need to be swapped when combining them with Fender stock ones, but I don't know if that applies to humbuckers as well.
Thanks very much for help and responses in advance.
