2 mini toggles and a push pull

[goodtimes54321]

I have two humbuckers, 1 vol, and 1 tone, 1 three way toggle.
I want to add a dpdt on on on mini toggle and a push pull pot on the tone.

I want to do a series, parallel, split on both pickups ....can I do this on one mini
Then do a phase shift on the push pull?

I see a similiar set up in the "other/misc " - wiring misc area but it only seems to be showing 1 pick up.....can I just hook the same wires from each pick up to the same places on the one mini switch to get the same modes on both pickups? or is there a slight variation when doing it with two pickups.

Then I seem to have a problem with the phase reversal because the output from two pickups is going to the phase reversal.

Am I going to need two dpdt switches to be able to get the phase reversal???? One of the dpdt output would go to the push pull for reversal?
Thanks

 

[AlexR]

Re: 2 mini toggles and a push pull

You need 1 mini toggle per pickup. You cannot connect both pickups to 1 - you will have them both on permanently. These need to be on/on/on style DPDT.

The OOP operation can be a pushpull as its one way or the other.

 

[goodtimes54321]

Re: 2 mini toggles and a push pull

You need 1 mini toggle per pickup. You cannot connect both pickups to 1 - you will have them both on permanently. These need to be on/on/on style DPDT.

The OOP operation can be a pushpull as its one way or the other.

Thanks...should be enough on the wiring website to get me through that.

1 switch for neck doing series, par, split going to push pull OOP
1 switch for bridge doing ser, par , split

 

[GuitarDoc]

Re: 2 mini toggles and a push pull

That is correct except that the DPDT on/on/on switches are going to do series/split/parallel (rather than series/parallel/split).