Any one using the hammerrail Billy corgan pickup set???

[big kurka]

So I bit the bullet and ordered a set of the Billy Corgan railhammer pickup set and I was wondering what your thoughts on them were. I've watch most of the videos on you tube and think they might be a pretty interesting pickup set. Been wanting to a p90 type of put and these are suppose to be pretty close to a p90 minus the hum. Really what to hear what you have to say about them especially if you actually tried them.

 

[Clint 55]

Re: Any one using the hammerrail Billy corgan pickup set???

Corgan is a beast.

 

[VinceT]

Re: Any one using the railhammer Billy corgan pickup set???

Re: Any one using the railhammer Billy corgan pickup set???

I've played the Corgan Sig guitar, and have a had two sets of Railhammer pickups in one of my Reverend guitars - Chisel/Anvil combo, which were too hot for me, so I swapped them out for Nuevo-90s (basically equivalent to a "standard" P90).

Bottom line, RH pickups do just what they say - tighten the low end, and round out the high end. I love them, particularly under any sort of drive.

Let us know how they are when you've got them installed.


Sent from my iPad using Tapatalk

 

[eclecticsynergy]

Re: Any one using the hammerrail Billy corgan pickup set???

I have a few Railhammers, good pickups and I like 'em a lot.
But have never tried the Corgan sigs.

 

[big kurka]

Re: Any one using the hammerrail Billy corgan pickup set???

Question for Vince T. You said you had a reverend guitar with the bass contour tone control. Would you be willing to take a picture of the electronics or draw a diagram of how it is wired up? There is so many different diagrams out there I don't know which one is correct. Also the pot for the bass control, was size and is it and what kinda taper is it. I just received my Railhammer BC set today and I'm going to put them in a shecter solo6 and wanted to use the reverend wiring setup. I would be very thankful if you could let me know. Thanks