ArtieToo V3rd Varient

[phobos]

Hey guys,
I have been a member of this forum for a couple of years now. This is however my first post so I will try not to ask too much.

So I have two telecaster projects to put together, I am just planning the wiring before I get the painting done.
One Telecaster is routed for two humbuckers, the other is routed for one humbucker.
The plan for the Two humbucker telecaster is as follows:
1 Volume Push Pull - Pulled gives partial coil tap (split with capacitors).
1 DPDT pickup selector.
I was hoping to use ArtieToo's V3rd using a DPDT, but I could not figure out how to implement a coil tap switch.
I found the following diagram on the DGP Studio Wiring site

I believe this does what I need it to do, had to redraw the diagram for simplicity. Coil tap to be added later.

I was wondering if any of the many wiring pros on this forum were able to critique my wiring diagram for me and let me know if there are any glaring errors.
I checked the original diagram to see if the schematic does what it claims, one can never be too certain.

Thank you for reading my long winded post, your feedback will be appreciated.

 

[Artie]

Re: ArtieToo V3rd Varient

Hey man. Welcome to the forum. Got your PM. As I noted, I'm back to working 60-hour weeks, but I'll get to it as soon as I can.

Artie

 

[phobos]

Re: ArtieToo V3rd Varient

Cheers Artie.

 

[GuitarDoc]

Re: ArtieToo V3rd Varient

It doesn't look like it will work to me. I can't see where you can get bridge or neck pup in series. With the selector switch in the up (bridge) position you are shorting the black, red, and white wires together. In the down position (neck), you are shorting the green, red, and white wires to ground. At best, either of these positions will give you split pup not series.

 

[phobos]

Re: ArtieToo V3rd Varient

Thanks Doc, looking at the red and white wires it appears I misplaced them. Will swap them around and remove the coil taps for easier viewing
Uploaded a corrected? and simpler version.