suislidE03
New member
Re: Avoiding death while working on amps ?
I was told that using the standby to discharge is the best way to do it.. on most amps. I think the best way to do this is to start with the amp off.. then just hit the standby switch and let it sit for a couple mins. After that, open it up and check several connections with a multimeter to make sure its drained. It usually will not totally drain, so you will have to drain it manually.
Of course, dont do this and screw up, i hold no responsibility. Maybe i shouldnt really post this.. i dunno.
I was told that using the standby to discharge is the best way to do it.. on most amps. I think the best way to do this is to start with the amp off.. then just hit the standby switch and let it sit for a couple mins. After that, open it up and check several connections with a multimeter to make sure its drained. It usually will not totally drain, so you will have to drain it manually.
Of course, dont do this and screw up, i hold no responsibility. Maybe i shouldnt really post this.. i dunno.