Best neck pickup to match SH14 Custom 5 bridge p/u?

Re: Best neck pickup to match SH14 Custom 5 bridge p/u?

Hello guys and gals ,
Is there 4 wire with bare ground (in total 5 wires I suppose ) is there any wire I can salvage from other products like old microphone cable or similar to use to replace short lead wires to re solder pickup ? I've heard people using usb cables and doubling them up because there a bit thin but I don't like that

ANY ONE KNOW SOME GOOD WIRE I CAN CUT FROM AN OLD CABLE TO USE FOR
SOME DUNCAN pups ( 4 wire with bare Ground) ?

Any thing I can repurpose and recycle ?
Anything BESIDEDS Cat .5 cables or Ethernet cable I HAVE A LOT OF OLD ELECTRONICS AND DONT WANNA CUT EVERY ONE TO FIND A PIECE OF WIRE obviously need to be gauge 20-24 22 would be the best

THANKS
 
Re: Best neck pickup to match SH14 Custom 5 bridge p/u?

Again, post this as its own topic, and you are bound to get more responses than in an old thread. Just start a new one.
 
Re: Best neck pickup to match SH14 Custom 5 bridge p/u?

I use the AP2 in the neck of my PRS CE22...sounds pretty good.
 
You must log in or register to reply here.
Back
Top