Blend pot questions

Grenade

Grenade

New member
I have a metal body resonator that I installed a K&K Bisquit Bridge peizo on. It sounds a bit thin so I am wanting to install a Lace Sensor Ultra Slim and add a Vol. and Blend controls. Can I wire these 2 straight to the Blend pot then Vol. and output jack? I using an external tube preamp. Thank you for your help.
 
Re: Blend pot questions

80% Indica, 20% Sativa and you should be good to go.

I kid, I kid, so you want to blend the two pickups using the pot? I need to double check a blending pot wire schematic I have laying around here somewhere. Most times I have used two volume pots to blend pickups (FX: on a Jazz bass)
 
Re: Blend pot questions

It didn't dawn on me to look at Bass wiring. That is what I want, without the tone control. Thanks.
 
Re: Blend pot questions

The only potential problem is if the two pickups have significantly different output levels, then the center detent on the blend will not really be the center balance between the two pickups. Perhaps you thought of that, just putting it out there to be sure.
 
You must log in or register to reply here.
Back
Top