Can someone witha 1936 cab take a few measurements for me?

[Kamanda~SD]

Hey guys! As some of you know I'm currently bulding a 2x12 cab, modelled after marshall's 1936 cab. I was sondering if someone could please take the following measurements for me (all on the outside!):

-Top of the cab to the top of the handles
-Anti skid trays (edge to tray)
-Jack plate (top to plate)

And please specify where the measurements go to (ex. Top of handle is 3" from top of cab, 2" from adge to outside edge of skid plate etc).

Thanks a bunch!


Also, another quick question. When cutting the holes for my speakers... I put the center 2" above the middle right? Also, do I cut a full 12" circle? AND...how far from the edge of the baffle should the middle point be? Thanks!

 

[Rich_S]

Re: Can someone witha 1936 cab take a few measurements for me?

Well, it's not a full 12" circle - it's 11 something. Check the Celestion or Eminence web page; they list the cutout diameter in each speakers "Specifications" section (if not on the web page, definitely on the .pdf.)