I was wondering if anyone might know of some sites that have wiring diagrams that deal with combining a full sized bridge humbucker with two single coils. I'm trying to figure out the best option for me in dealing with the need(?) to use pots of different values. Any help will be appreciated. Thanks.
Combining humbuckers/single coils
- Thread starter pbrown
- Start date
JB_From_Hell
Jomo's Nimions
Re: Combining humbuckers/single coils
Yeah... www.seymourduncan.com
Look under Support, then Schematics.
Yeah... www.seymourduncan.com
Look under Support, then Schematics.
Re: Combining humbuckers/single coils
Thanks. I checked the diagram (1 hum, 2sc, 1vol,1tone) and it uses 250k pots. Will this muddy the sound of the humbucker? I know I can wire two volume pots, with a 500k for the HB, but I really would like to have one master volume in the normal position.
Thanks. I checked the diagram (1 hum, 2sc, 1vol,1tone) and it uses 250k pots. Will this muddy the sound of the humbucker? I know I can wire two volume pots, with a 500k for the HB, but I really would like to have one master volume in the normal position.
JB_From_Hell
Jomo's Nimions
Re: Combining humbuckers/single coils
You could use a 500k, and put a capacitor on each of the singles, to darken them up a bit. Or, hook them up to their own tone knob, and keep it rolled back a bit.
You could use a 500k, and put a capacitor on each of the singles, to darken them up a bit. Or, hook them up to their own tone knob, and keep it rolled back a bit.
