About 6 months ago I wired a Custom Custom into my Strat and did'nt like what I was hearing which may have been my fault. I've also got 2 Dimarzio pickups wired up (Virtual 2's) and I may have had the CC wired out of phase. With the pickups selector switch in position 1 the CC was nothing but a loud midrange mess and in position 2 (bridge and middle combined) it was extremeley thin sounding. According the the schematic the black wire was to be used as the hot output. Because I'm also using Dimarzios should I have used one of the other wires on the CC as the hot output? Thanks.
Did I wire this wrong?
- Thread starter Mike M.
- Start date
rspst14
Tone Cat
Re: Did I wire this wrong?
As long as you wired the Duncan and the Dimarzios both in phase, you wired them correctly. When selected by itself, phase does not matter. Phase is only important when you have two pickups selected at once. Certain pickups are reversed in phase from others when wired properly, but I'm pretty sure that's not a problem when mixing Duncans and Dimarzios.
Ryan
As long as you wired the Duncan and the Dimarzios both in phase, you wired them correctly. When selected by itself, phase does not matter. Phase is only important when you have two pickups selected at once. Certain pickups are reversed in phase from others when wired properly, but I'm pretty sure that's not a problem when mixing Duncans and Dimarzios.
Ryan
Re: Did I wire this wrong?
Hmmm. I still think something was wrong because I've heard clips of the CC by forum members which is what led me to try it. Again, the CC by itself was so loud and midrange heavy I thought my speaker was going to blow. I even lowered it to the point where I had the pickups top surface even with the pickguard and it was still to much.
Hmmm. I still think something was wrong because I've heard clips of the CC by forum members which is what led me to try it. Again, the CC by itself was so loud and midrange heavy I thought my speaker was going to blow. I even lowered it to the point where I had the pickups top surface even with the pickguard and it was still to much.
flank
New member
Re: Did I wire this wrong?
the CC by itself is correct no matter what you did........the signal is loud and mid heavy, so its obviously not a bad or loose connection on the CC
now the in between position is thin, that means that those 2 pickups are out of phase
unfortunately, it just seems that CC is not the pickup for you if you think its too loud and mid heavy
the CC by itself is correct no matter what you did........the signal is loud and mid heavy, so its obviously not a bad or loose connection on the CC
now the in between position is thin, that means that those 2 pickups are out of phase
unfortunately, it just seems that CC is not the pickup for you if you think its too loud and mid heavy
Re: Did I wire this wrong?
Reverse the CC's black and green leads. As a side note I'm pretty sure the VV has a South magnetic polarity, unlike the SD stacks which are North. The real question would be whether you are coil tapping or not in the 2 & 4 positions (which is unecessary with an HB and two stacks). Then you'd have to do a bit of rewiring.
flank said:
Reverse the CC's black and green leads. As a side note I'm pretty sure the VV has a South magnetic polarity, unlike the SD stacks which are North. The real question would be whether you are coil tapping or not in the 2 & 4 positions (which is unecessary with an HB and two stacks). Then you'd have to do a bit of rewiring.
Similar threads
